Description

KOSTYRKA 1410.40

The KOSTYRKA® air-oil hydraulic pressure intensifiers of this series are primarily used where small amounts of high-pressure oil are needed, but where only compressed air is available. Since October 2015, the proven KOSTYRKA® Series 1410 hydraulic pressure intensifiers have been supplied with an aluminum profile housing (exception 1410.10). Advantages here are reducing the weight und special versions to be realized quickly. In addition to mounting via a base plate, it is now also possible the threads on the front for mounting. Furthermore it is possible to place a magnetic sensor into the grooves, and this can be used to defect the position of the intensification piston

Connection
On the pneumatic side, the hydraulic pressure intensifiers can be controlled via a single 2-way /3-way valve. Due to the volume compression of the pressure oil (approx. 0.7% per 100 bar) that occurs in the entire high-pressure range, the shortest possible feed lines with a sufficient cross section should be used on the hydraulic side. Otherwise it may be that the displacement volume of the hydraulic pressure intensifier is not sufficient for perfect functioning of the consumer. We recommend screw connections with an O-ring seal on the front side.

working air pressure: 3 – 7 bar · working fluid: hydraulic oils with a viscosity up to 32 mm²/s (32 cSt) at 40°C · installation position: horizontal or upright, with the high-pressure section at the top.